OS-Base Yamaha Tenere 700 (rackless harness)
Fits your Tenere 700. No drilling.
- Throwover straps hook to the subframe. No drilling.
- Straps go over the seat. Cinch until the bag stops moving.
- Smallest exhaust gap of the three. Heat shield matters most here.
- Watch the scuff zone on the rear plastics.
- Keep the load light and balanced side to side.
- DRILLING
- No drilling
- HEAT SHIELD
- Not published
- Mount
- soft rackless
- Drilling
- none
- Exhaust side: heat shield Not published
- Vendor load limit
- Not published
- Install
- easy
- Weight
- Not published
- Price band
- mid
- Warranty
- 10-year guarantee
- Pairs with
- no rack, and it will not clear rear-peg tail racks
- Kriega officially warns the harness sides can abrade the T7 side panels; apply clear protective film at contact points. T7 forum caution: the skin-tight T7 version will NOT fit if a tail rack is bolted to the four rear pegs. Purpose-shaped body keeps distance from the exhaust.
- 01Bolt the included Tenere loops to the subframe under the seat
- 02Lay the OS-Base harness over the seat
- 03Hook the lower straps around the rear footpeg mounts
- 04Clip OS-6/OS-12/OS-18 packs onto the harness
- 05Apply protective film where the harness touches plastics
One email. Your exact setup. No spam.